Visit “Cutting” if you want to know about the cutting work of the paper, resin, film, rubber, vinyl, glass fiber and so on.

Choice of paper
cutting machine
Inquiries are welcome. Contact us
by phone, by fax,
or by e-mail.

Top page > In view of cutting width

  Key point of selection and cautionary points
The item to be cut is loaded in the opening (cutting width) of the cutting machine.
The cutting width is almost the same as the depth where the item is contained.

The cutting machine is divided into models according to the cutting width as shown in the figure below, so that you should choose the model according to the width and depth of the item to be cut. About 10cm larger than the target width of the item is recommended. This is to reserve the margin for handling the item with hands.

In addition, to cut the side or back in addition to the front of the item, the item must be turned on the cutting machine.
In this case, the length of the diagonal line of the item is necessary as a cutting width.